REC Aktiv BMS 4S (for 12V system) Victron Comp

Lager
På lager
Pris
kr 4 790,00
Varenr.
10409
EAN
7090055930387
REC REC Aktiv BMS for 4 battericeller

REC sin aktive BMS for 4 celler koblet i serie, vil gi aktiv bi-directional ballansering. Denne BMS-en er velprøvd, og vi på Farco har erfaring med den tilbake til 2015. Dette betyr at den står i mange anlegg og er gjennomtestet. At den er Aktiv gjør at den har stor kapasitet. Fra 2019 leverer vi denne normalt i en utgave som er Victron Kompantibel. Dette gjør at BMS styrer ladespenning og styrke, og dette fungerer meget godt med Victron produkter som kommuniserer via GX løsning med VE.BUS

Husk å bestille med Kablesett sammen med BMS!

REC har laget en Video som viser en standard oppkobling.

Tekniske data:

Li-PO, LiFePO4, LiFeYPO4, LiCoO2, LiMnNiCo and LiMnO4 Lithium-Ion chemistry
4 series connected cells per unit
high efficiency 2 A bi-directional active balancing (pack to cell and cell to pack)
IP65 protection enclosure, AMP 35 pin water resistant connector
2 ? 5 V measuring range, 2 mV accuracy
up to 2 digital temperature sensors
shunt current measurement
robust and small design
galvanically isolated RS-485 and CAN communication protocol
two programmable fused relay output
two programmable fused digital output
ON/OFF switch
LED and buzzer status indication
bootloader
error LED + buzzer indicator
PC user interface for changing settings, data-logging and firmware update
compatible with REC LCD touch display for monitoring
also compatible with Victron inverters for solar applications
 Microcontroller:

low power microcontroller RTC
custom made software with bootloader for remote firmware update
60 mW self power consumption with disabled CAN and all outputs
 RS - 485 communication:

galvanically isolated RS-485 communication
Slave configuration
RS-485 driver primary side supply is activated with Master connection to save energy consumption
fully compatible with REC LCD touch display and PC user interface BMS Master control
 Active Balancing:

2A cell equalizing with active balancing with synchronous flyback bi-directional energy transfer: cell to pack and pack to cell
top side and bottom side balancing prolong the cycle duration due to the weakest cell
 Outputs:

two fused relay outputs with NO and NC pins
two fused galvanically isolated/non-isolated digital outputs with PWM option
 Galvanically Isolated CAN:

galvanically isolated CAN
100, 125, 250, 500, 1 MHz bit-rate selection
message programming
disable option
 Complete wiring of ABMS connector:

5 cells wires (l = 1m)
relays, digital output wires (l = 0.5m)
RS485 cable (l = 0.5m)
CAN cable (l = 0.5m)
remote ON/OFF switch (l = 1m)
ABMS connector
 Dimensions:

width with mounting pads = 135 mm
width = 105 mm
length with connector = 111 mm
length = 104 mm
height = 44 mm
connector width = 59.5 mm
hole diameter = 4.5 mm

We suggest M4 screws for mounting.

Dokumenter

Din nettleser er utdatert!

For å kunne bruke alle funksjoner på nettsiden må du oppdatere nettleseren. Oppdater min nettleser nå

×